How to Measure Yourself for a Suit (Including Inseam)

Tailor taking a man's chest measurement with a tape
Loading... 1 view(s)
How to Measure Yourself for a Suit (Including Inseam)

To measure your inseam, stand straight in the shoes you will wear, feet slightly apart, and run a soft tape from the crotch seam straight down the inside of your leg to the point where you want the trouser hem to end. That number, together with your outseam, waist, hip, thigh and leg opening, decides how a pair of suit trousers fits and where it breaks on the shoe.

This article covers the inseam in detail and the mistakes people make on every other suit measurement. For the step-by-step instructions for each field, use our measuring guide; keep it open in another tab while you read.

Measuring inseam: three ways that work

With a helper (best)

  1. Wear thin trousers that fit you at the crotch, or underwear, and the shoes for the suit.
  2. Stand straight, weight on both feet, looking ahead. Looking down shortens the reading.
  3. Your helper holds the end of the tape at the crotch seam and runs it down the inside of the leg to the hem point you chose, usually where the shoe heel begins.
  4. Read the number at the hem point, then repeat on the other leg.

On your own, with a book

Stand against a wall in your shoes and slide a hardback book up between your legs, spine upward, until it rests firmly at the crotch. Hold it level, mark the wall at the top of the spine, step away and measure from the mark down to the floor. Then subtract the distance from the floor to where you want the hem, since this method measures to the floor.

Cross-checking with trousers you own

Lay a pair of dress trousers that are the right length flat, and measure from the crotch seam down the inside leg seam to the hem. Use it as a sanity check on your body measurement. If the two differ a lot, measure your body again rather than averaging them.

Inseam vs outseam

The inseam runs from the crotch to the hem; the outseam runs from the top of the waistband down the outside of the leg to the same hem point. The difference between the two is the rise, the distance from crotch to waistband. Because both are measured to the same hem point, that point is where you choose your break. Our trouser break guide shows where to set it for your height and occasion.

Common mistakes, measurement by measurement

MeasurementCommon mistakeWhat it does to the suitHow to avoid it
ShoulderMeasuring straight across in a line instead of following the curve of the upper backShoulders too narrow; sleeves pull and the jacket dents below the padHave a helper follow the back, bone to bone
ChestTape sliding down at the back, or puffing the chest outJacket too tight across the back or too loose in frontCheck the tape is level in a mirror; breathe normally
WaistMeasuring where jeans sit instead of where dress trousers sitTrousers sit too low and the rise looks wrongMeasure where you wear dress trousers, a little higher than jeans
SleeveMeasuring with the arm locked straightSleeves finish short when you moveBend the elbow slightly and measure over it
HipMeasuring at the hip bonesTight seat, pockets that flare openMeasure around the fullest part of the seat, checked side-on
OutseamMeasuring from the natural waist instead of where you took the waist measurementRise and length both wrongStart exactly where you measured Waist
InseamMeasuring barefoot, or looking downTrousers too short in shoesWear the shoes; keep your head up
ThighMeasuring too low on the leg, or with the muscle flexedTight thighs when you sitAbout an inch below the crotch, leg relaxed
Leg openingEntering a body measurement (the ankle) instead of the hem width you wantHems far too narrowMeasure the hem of trousers you like flat and double it
Shirt neckPulling the tape tight with no finger underneathCollar that won't button comfortablyKeep one finger under the tape

A two-minute self-check before you order

  • Your outseam is longer than your inseam, by roughly the distance from your crotch to your waistband.
  • Your hip measurement is plausible next to your waist; for most men the seat is the larger of the two.
  • Left and right leg readings agree, or you know why they don't.
  • Every number is in inches. If you measured in centimeters, convert before entering.

These checks catch typing errors, which are more common than measuring errors. A tailor also reviews every made-to-measure order for numbers that don't fit together and contacts you before cutting if something looks off.

Measured? Here is where it goes

Every suit, tuxedo and pair of trousers in our made-to-measure range lets you choose "Made to measure (your measurements)" in place of a standard size. If you would rather buy by size, the suit size chart explains how standard sizes compare with your chest and waist. Either way, our fit promise covers you: if it doesn't fit, tell us within 30 days of delivery for a free remake or up to $100 towards a local tailor.

Questions

Is inseam the same as trouser length?

For most shops, yes: trouser length labels such as 32 or 34 refer to the inseam. Outseam is the longer, outside measurement that includes the rise.

Should I measure my inseam with shoes on?

Yes, ideally in the shoes you will wear with the suit. Heel height changes where the hem should end, and dress shoes sit differently from sneakers.

Can I measure for a suit without help?

Most measurements, yes, using a mirror and the book method for inseam. The shoulder is the one that really needs a second person.